![thread stuck in device driver gtx 930 thread stuck in device driver gtx 930](https://www.drivers.com/wp-content/uploads/2019/04/thread-stuck-device-driver-hardware-acceleration.jpg)
Typically with a motherboard that supports UEFI, and usually means you're picking a Legacy boot device
#Thread stuck in device driver gtx 930 install#
Try different USB ports for the USB install drive use a USB2 port if you have one.Ĭan't boot: "Reboot and select proper boot device" error.Unplug all devices except your keyboard, mouse, and the install USB drive and try again.One person reported this failure when BIOS was on Legacy and UEFI boot, but with BIOS set to UEFI boot only it worked.If you don't see the USB listed, check the BIOS for allowing boot UEFI devices and/or boot Legacy devices. If you have two entries for the USB drive (one legacy, one UEFI) try both. Use the BIOS hotkey if needed to bring up a boot device menu and pick a specific boot device. Make sure you're booting to the Clover USB or drive.You must choose the USB or system drive in UEFI mode for the hard drive to get Clover to load. This seems to indicate that you're not booting to the USB successfully it could be that the system is attempting to boot El Capitan using Chimera in legacy mode from the existing drive. If you don't have any USB 2 ports, you can try to boot through Boot Maintenance Manager.Ĭan't find /System/Library/Kernels/kernel.Use a USB 2 port or hub and a USB 2 drive for best results. Try recommended settings for X58 installĬlover doesn't boot, system boots to blue and grey Boot Maintenance Manager.Seen on a x58 and z68 with Legacy UniBeast USB.Then use your BIOS hotkey to select a boot device as above.Ĭlover doesn't boot, BIOS shows Boot1: /boot then on a new line 5 If the UEFI entry for your drive doesn't appear, look for CSM in BIOS and either set it to disabled altogether or UEFI only.Select "UEFI:YourDrive" (either system drive or USB install drive, depending) Use your BIOS hotkey to select a boot device.BIOS is trying to boot legacy but the install was done UEFI.Install Clover again to the El Capitan driveĬlover doesn't boot, BIOS shows Boot1: error.Run "diskutil corestorage revert /dev/diskX" (where X is the drive with CoreStorage).Boot from the install USB to El Capitan (or Recovery).
#Thread stuck in device driver gtx 930 software#
from an old software RAID or encrypted drive setup) and you can do without it: If you can boot from USB but not system drive, and one of the drives is using CoreStorage (e.g.
![thread stuck in device driver gtx 930 thread stuck in device driver gtx 930](https://tencomputer.com/wp-content/uploads/2019/03/advanced-display-settings.jpg)